Home Small Boat Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

Re: Homemade outboard motor using briggs 2hp

68.4.211.26

Finally started some welding tonight, a bit concerned about a few things..
1. my welding is pretty bad hehe
2. the pipe that I am using is galvanized something welded to steel, hopefully these things weld ok
3. my welder is for small hobbies stuff like that so it may not be as deep as it should be.
Anyway I was happy the see a general form start to take place. The link below shows some photos of the progress-double click the small photos to see larger ones...
http://machnumber2.50megs.com/photos/outboard2/photos/outboard.html



This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]


Follow Ups Full Thread
Follow Ups


You can not post to an archived thread.