Welcome! Need support, you got it. Or share you ideas and experiences.
In Reply to: Re: The Next Hurdle in the old 15Hp Johnson saga posted by machnumber2 on April 21, 2003 at 11:23:51:
I think it would pretty much overheat, and stall out. it might also act/sound/run funny as it approached overheat status. I do not think it will overheat, as I said, I had it apart, and with another pump sent water throught the system,, its circulating, just not making the tatle tale. the motor ran over 1/2 hour in the bucket at trolling speed with the prop turning and was cool to the touch everywhere. I dont think heat is a problem.
I did not get to take the boat out easter sunday. The repairs ( fiberglassing ) went very well as expected, its all cured and painted ready for action.
There is still allot of ice everywhere around here, but there is a place or 2 I could go. Probably wont get the chance to get out now til the weekend. Maybe Ill get my casting deck finished sometime this week.
Will add some information since i have given 3 of the old 15 Johnson/
Evinrudes to the junk yard because of the water pump. The clincher is
to change the impeller or do much of anything to it you have to lower
the lower unit and that means lower the drive shaft and that means the
shaft must slip out of the base of the power head. The upper endof
the drive shaft is a splined fitting into the base of the power head
and unfortunately they rust and no amount of pulling, banging, or
liquid wrench will make it turn loose. I could not find a dealer or
repair shop that had a solution. That pin you mentioned is made onto
the drive shaft and should not have been free. It sounds like the
previous owner worked on the water pump and saw the light.
If you did drop the shaft down and got the top of the pump off
then you are home free but if you didn't drop the drive shaft then
the pump is probably not working. Put the ear muffs and water to
the water intake on the lower unit and start the engine and if the
water pump is working it will push the water out through the propeller
hub with some force but not a lot.
Good luck and if you find a sollution to getting that shaft out
i would like to know it. The stream from the telltale hole should
spurt out at least two inch or so.
I guess I got lucky then, becuse my shaft comes out without any problems. My manule recomends a touch of greese when putting it together each time to help it apart next time.
This post is made possible by the generous support of people like you and our sponsors: