• Re: 9.5 lower unit - akendall 13:03:40 10/07/02 (1)
  In Reply to: 9.5 lower unit posted by jtrnr50 on October 04, 2002 at 12:39:08:

  jtrnr50,

  Water in the gear lube is a serious issue - especially if allowed to remain in the lower unit for a long duration (rust + heat + friction = worn out gears). Yes, you probably need seals. If you're mechanically inclinded you may be able to perform the task yourself, but it's tough - get a manual if so.

  I would suggest taking it to a mechanic if you don't match the profile above - get a pressure test on the lower unit, then the mechanic can replace the needed seals when the leg is off. This has it's advantages because you will/should be covered under a warranty if the job isn't done correctly!

  Last bit of advice - get the mechanic to replace the water pump while the lower unit is off - should only cost about $20 and the labour has already been done to get at it while replacing the seals...

  ~Andrew
  
  

  ---

  • Re: 9.5 lower unit - jtrnr50 08:15:59 10/08/02 (0)
    In Reply to: Re: 9.5 lower unit posted by akendall on October 07, 2002 at 13:03:40:

    Thanks Andrew, I'll take it in. Good advice........
    
    

    ---

This post is made possible by the generous support of people like you and our sponsors:

Parts Connexion

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---