Welcome! Need support, you got it. Or share you ideas and experiences.
Could somone please share their opinion about the following idea? I just purchased a 12 foot inflatable boat and plan to propell it with an electic trolling motor. I know it will work for a few hours at least, since a buddy and i tried the same with a 12 foot rigid hull boat and had about 3 - 4 hours of driving time. However i would like to rig up a solar panel to charge the battery while in use. Now i doubt it would keep the battery fully charged, however i am sure it would help extend the battery use on the lake so i would not have to go back to shore to charge up so soon.The question is will this work as easy as i think it should? If so why is no one else doing it?
Follow Ups:
Hi Vaughn,Powering an inflatable with an electric motor…. One thing to keep in mind—the battery system really is the ‘motor’ and the type of system and quality of the batteries, along with the charging system, will determine the length of trolling time.
Firstly, a 12’ inflatable, like the Avon/Achilles type, does not have an efficient motion through water. If you have ever tried to row one of these vessels you will find the have no ‘carry’—no forward motion after the stroke of the oars. Moving, even at a trolling speed, will require more ‘juice’ for the electric motor. One way to overcome this is to place on board a bigger battery system set up in parallel mode—i.e. 2 batteries hooked up in parallel. At this point something like a pair of Gel Cell (calcium type, not lead acid type) as they have an ‘at rest’ voltage, after proper charging, of 13.8 to 14.2 volts. This is much higher than a lead acid type which after a good charge will have an ‘at rest’ voltage of 12.4 to 12.7 volts. The ‘strapping’ between the batteries should be thick cables. The minus cable to the motor should be hooked to one battery of the pair, while the plus motor cable goes to the other battery. This will effect a stable even ‘pull’ from the battery system while the motor is running.
As to a solar cell “charging” the battery system while in use… Your boat can’t carry enough solar cells—big enough—to do the deed (maybe someday—solar panel efficiency has gone from 7% in the mid 80’s to about 16% today). A better way is to ‘starve off’ battery demise. Look for an efficient VOLTAGE solar cell—not a solar cell that delivers a lot of amperes and hook it up to the unused plus and minus of each battery (meaning opposite the motor cables). You can put Ohm’s Law to use by keeping the battery voltage as high as possible (Gel Cells) and by pumping into the batteries a decently high voltage from the solar cell while underway—say 16 to 18+ volts. Remember, this solar cell must have diodes to prevent reverse flow of electrons or the batteries that will ‘cook’ the panel. Ohm’s Law says that the higher voltage equals less amperes drawn. As your battery system looses voltage, more amperes rush to the motor like a ‘ crash of rhinoceroses’ or a ‘knot of toads’ or a ‘shoal of bass’ and the battery system losses power--faster and faster--as voltage drops.
The last part of a good battery motor system is to have a proper charger. One should invest in a 3 or 4 stage charging system to properly get the batteries up to full capacity. These chargers take a low battery and hit it first with a relatively high voltage. Then, after 20 minutes or so, they lower voltage and begin to push in amperes. As the battery nears it’s topping off point, about 15% below capacity, the charger backs off again and trickles in the last of the amps. Now you have a full capacity charge on the system and are ready to go again—but the next day--as this takes time and will need to be done overnight.
Sounds like one could have as much fun as a 'pod of whales' after setting up a trolling system like the above. Let us know your progress and experiences.
Thanks Thom, I appreciate the info. It appears that this undertaking will be more involved than i initally expected. I still think it would be worth it, enviromentally but finacially it would take some time before one would receice your moneys worth. It will be a fun project though!
Any suggestions for a battery for a trolling motor(endura 30) on a 14' inflatable
With a 14' inflatable you have some carrying capacity. The Calcium Gell Cell type battery is a good bet as their at rest voltage is high-13.4 volts or so compared to a lead acid types at rest voltage of 12.4. Another type is the combination lead calcium AGM absorbed glass mat type as on the site: powerstride.com They have some mighty small sized units that could be paralleled for longer run time and they have 3 stage type chargers too. One would have to build some quick release cables to make the portability factor for off boat charging easier...
![]()
This post is made possible by the generous support of people like you and our sponsors: