Home Small Boat Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

Re: Help! Inboard / Outboard Conversion

216.37.153.246

I converted a 18footer inboard with a 135 omc to a 200 hp mercury outboard. I found no problems doing so, just use common sense.
1. I removed the engine, and stern drive.
2. I filled in that large hole, while plywood, then fiberglass filler, then fibercloth, sanding, then paint. on the outside I put 1/4inch stainless steel plate across the whole rear end. On the inside, I also put 1/4 inch plain steel inside, thus I used stainless steel bolts,washers, and nuts, mostly in the 1/2inch range.
3. The hardest part was re-treading 1/2bolts for my use, this took a air-torgue wrench like for removing nuts off of studs from a car tire and a heavy duty vice. I also cracked two treaders because of the force and the number of bolts I did around 40 of them. The boat does not leak, the boat goes like a bat out of hell, my new transom, is a jack plate made in flordia. good luck, and it was fun doing the boat. joe stachyra


This post is made possible by the generous support of people like you and our sponsors:
  K&K Audio / Lundahl Transformers   [ K&K Audio / Lundahl Transformers Forum ]


Follow Ups Full Thread
Follow Ups
  • Re: Help! Inboard / Outboard Conversion - joe stachyra 15:46:39 10/14/02 (0)


You can not post to an archived thread.