Welcome! Need support, you got it. Or share you ideas and experiences.
i can get a deal on a 1976 fiberglass runabout tri-hull 16 foot with a 40 horse johnson not it my question is what will it take to float this boat i am lookin to go in 2 foot of water also. its does not have tilt and trim will this be a big deal ?
![]()
Follow Ups:
that boat should have no problems in 2 feet of water. The boat itself should need about 6 ta 8 inches,. With the motor lowered, you probably need a foot too 14 inches.How big a deal is a tilt and trim? Well, The tilt is prety much to raise and lower the motor in and out of the water, the Trim is used to allow you to force plane ( bring the nose down ).
People that dont have a tilt & trim device manulaly raise and lower the motor to tilt. and usualy have to move wieght around the boat to make it plane.
![]()
thanks for the info i might be able to get the boat,motor, and trailer (homemade)for about 150$ the boat has not seen the water in 2 years and i know right off it will need a new steering cable but he said the engine was flushed after every use.i will have to get the motor running again after sitting so long. but i think this will make a nice first boat with alittle work
![]()
make sure you change the water impellor on that puppy before a try to run it too much,, after sitting for a few years, its a good move.
![]()
This post is made possible by the generous support of people like you and our sponsors: