I would like to convert my inflatable over to a hard floor from the high pressure inflatable floor design. How do I go about doing this?Thanks,
Mike
Follow Ups:
- Re: Installing hard bottom in inflatable... - gwh1bass 07:01:29 03/12/04
(0)
- In Reply to: Installing hard bottom in inflatable... posted by BCR #226 on September 29, 2003 at 04:59:29:
I would also like advise. I've got a 9'-6" West Marine made by Zodiac inflatable boat. The floor system is missing although I still have the floor board stringers. I have seen the boat with floor installed and took a few notes, so I am going to try to fabricate my own floor system. I still need to find a source for the aluminum "H" channel that holds adjacent pieces of flooring together. Its either that or try to make the floor out of one piece of pylwood. I don't see how this would be a problem, other than portability.
This post is made possible by the generous support of people like you and our sponsors:
You can not post to an archived thread.
[
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]